A. The characteristics of the oil pan is:
Low cost, large printing area, easy installation and removal, simple operation, directly put the ink pour into oil pan, can print.Installation process of oil pan, oil pan is simple, the erection and dismantling of the oil pan installed on screw, adjust to a location in the middle of the table, using the wrench to tighten it, and then install the scraper and rubber head;Then sun good steel plate into the oil pan, oil pad printing plate with a wrench in front of the screw, will be the inside of the oil pan steel plate fixation;Suitable amount of ink is poured into the oil pan and into the oil pan to human right amount open oil-water mixed with uniform, general ink depth of no more than the oil pan steel plate height about 2 mm.After the launch pad printing machine back and forth with scraper scrape well pad printing ink.To print the product after the preparation, can start printing.Note that should be paid attention to when long time do not use the pad printing machine to remove oil pan, will ink wash clean with open water, arrange another time to use again.
Second, the characteristics of the oil cup type filling device is:
Oil cup pad printing machine is the most important characteristics of the oil cup of environmental protection, minimize waste ink and volatile odor;Using imported ceramic cup ring, ink can be placed for long, concentration is still stable.Thriftiness ink time.Increase the print products, cost savings.Oil cup installation process: the installation of the steel to the magnetic slates, fastening screws, lift the oil cup bracket, put steel piece, twist screws, put the ink set into the oil cup again, the oil cup is installed on the steel plate, the fixed oil cup holder, boot adjust position can be printed.
在线客服